Troubleshooting: I Hear Only One Side When I Playback A Call
Please note: this is legacy documentation. Please check out https://docs.miarec.com/all/ for the most up-to-date documentation and user guides.
This problem can be caused by one of the following:
- Your headphones play incorrectly in stereo audio
- Firewall is running on your computer, which blocks one way of network traffic
- QoS (802.1p) is not supported by Network Interface Card
- Out-of-date drivers for Network Interface Card
- One of the network cables, which are connected to HUB, is broken
- RTP packets are non-symmetric or RTP SyncId is changed unexpectedly in a middle of a call
- Changes in VoIP protocol or "bug" inside MiaRec
1. Your headphones play incorrectly in stereo audio
First of all, check if your headphones play correctly in audio stereo format. By default, MiaRec saves audio in stereo format. One call party is recorded in the left audio channel and the other party is recorded in the right audio channel. Try to play the file on another computer and use different headphones.
If you cannot do that, then send a sample audio file to us for review. We will tell you for sure if your audio file contains two sides or only one side.
2. Firewall is running on your computer, which blocks one way of network traffic
Some firewalls may block one side of the conversation. Try to disable the firewall on your computer and make a test call again. Note, that many antiviruses today include their own built-in firewall. Check the settings of your antivirus and make sure that the firewall is disabled or configured correctly. Below you will find step-by-step configuration guides for some known firewalls:
3. QoS (802.1p) is not supported by Network Interface Card
This problem sometimes occurs with 3Com network interface cards.
4. Out-of-date drivers for Network Interface Card
This problem occurs with some old drivers on Windows XP. On newer operating systems (Vista, 7, 2008) such a problem should not occur.
5. One of the network cables, which are connected to HUB, is broken
Such a problem occurs only if HUB is used. Switch with Port Mirroring is not affected by this problem. Try to replace network cables, which are connected to HUB. Or at least rotate them (for example, exchange cables "Modem -> Router" and "HUB -> Computer"). Make sure that all cables are firmly plugged into connectors on all devices.
6. RTP packets are non-symmetric or RTP SyncId is changed unexpectedly in a middle of a call
Some VoIP phones use non-symmetric ports for sending and receiving of RTP packets. Others may change RTP SyncId in the middle of a call. Both these reasons will cause a situation when MiaRec creates two files for a single call. You will see inside MiaRec two call recordings instead of one. The first file will have audio from one side of the conversation and the second file will have audio from the other side. The second file may have no audio at all if your license doesn't allow the recording of more than one concurrent call. Below you will find a workaround for this non-standard behavior of your phone.
But we suggest you contact us and collect the log as described in point 7 because this issue may be caused also by a bug inside MiaRec.
Workaround for MiaRec Solo:
Go to Settings -> Advanced and enable the following options:
- Ignore UDP port change
- Ignore RTP SyncSourceId change
Workaround for MiaRec Business:
Open configuration file MiaRec.ini and change following options:
7. Changes in VoIP protocol or "bug" inside MiaRec
If none of the above helped, please collect the network log and send it to our support team for investigation.